Nebulized Peroxide

from Dr. J. Mercola's website 

The above link to this video and information does not work and now brings you to this screen shown below.  May God watch over him and all the truth warriors.

 

Distilled Water-16 oz

1 teaspoon -Good Quality Salt

3/4 teaspoon-Food Grade Hydrogen Peroxide 12%

 

◦ Fill a 16 ounce pint jar (e.g. a Ball jar) with distilled water. Do not use tap water!

 

◦ Add a level teaspoon of good quality salt (pink Himalayan from a reputable source) to the water and stir to dissolve. It may take a few minutes. You now have a jar of “normal saline” which is defined as .09% sodium chloride (salt), which translates to 9 g/L. A teaspoon is a little less than 5 g and the 16 ounce jar is about half of a liter.

 

◦ Next add 3/4 of a teaspoon of the hydrogen peroxide into the jar which now consists of a normal saline solution. *** You now have 0.1% hydrogen peroxide diluted in normal saline.

 

◦ LABEL THE JAR WITH CONTENTS AND DATE. Keep in the fridge since there are no stabilizers in the solution. It should last at least a year and be much more than you will actually need.

 

◦ This should ideally be used as soon as you get an upper respiratory infection but should still work very well even if used later on in the infection process.

 

  • Suggested amount to use during each nebulizing session is about 5 mL. 

 

  • Nebulize until that amount is gone. 

 

  • If the symptoms are bad, nebulize every hour and then once you start feeling better, every 4 to 6 hours. 

 

  • Remember to use the nebulizer face mask, since it is crucial to inhale the solution up your nose.

 

 

Buy desktop nebulizer and adult face mask from:     www.healthalert.com

Food Grade Hydrogen Peroxide 12%:  https://vivadoria.com/

 

(there are other brands of nebulizers and hydrogen peroxide; I do not order from amazon)

Screen Shot 2021-04-29 at 3.49.58 PM.png

COVID Hydrogen Peroxide Inhalation Therapy #2

Hydrogen peroxide inhalation therapy to treat symptoms of COVID-19 from Bill Munro.

The following is an excerpt from EarthClinic.com 's story "Hydrogen Peroxide Inhalation Therapy for COVID-19"

Hydrogen Peroxide Inhalation was first introduced to the world on Earth Clinic over 15 years ago by Bill Munro of Michigan. Mr. Munro, who died at the rip age of 90, used his delivery method for over 30 years to treat virus symptoms, prostate issues, lung issues, and more.

Hydrogen Peroxide Inhalation Method Instructions

  1. Empty out the contents of a saline nasal pump and sterilize the bottle with hot soapy water. Make sure you then rinse out all the soap.

  2. Fill the empty, sterilized nasal pump with 3% peroxide. Use 3% food grade peroxide if you can get it in your country.

  3. Point bottle at the back of your throat and, on a sharp inhale, pump the spray 6 times. DO NOT INHALE IT UP THE NOSE!! (People misread Bill's instructions from time to time and spray it up the nostrils!!)

  4. Do this 4-6 times a day. If you are trying to get rid of a virus, pump every 2 hours or so.

  5. It should take about 36 - 48 hours to get rid of a virus. If it's an insipid virus that's been in your system for some time, it may take up to 2 weeks. For other conditions like cancer, please read the feedback in our table of contents section on this page and on our cancer remedy pages for more information from our readers.

Note: Before you start this technique, see how little of the peroxide you are actually inhaling by pumping 6 times into a teaspoon. It's a tiny amount.

Cautions

We do not suggest the use of peroxide higher than 3% solution for this inhaling method. H202 is dangerous at dosages higher than 3% if not properly diluted.

Also, always use food grade peroxide if you can obtain it. When we first published this method in 2004, you could not get 3% food grade peroxide, only 35%. Bill Munro never used food grade. Rather, he used 3% plain peroxide from the pharmacy for many years until his death at age 90 in 2014.